Herunterladen Inhalt Inhalt Diese Seite drucken

Fit The Gas Cylinder; Adaptation Of Device To Flux-Cored Welding Wire With Inert Gas - Parkside PSGS 120 A1 Bedienungs- Und Sicherheitshinweise

4-in-1-kompaktschweissgerät
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
Feed roll, welding nozzle and wire
cross-section must be compatible with
one another.
The device is suitable for wire reels
weighing up to maximum 1000 g.
z Fit the gas cylinder
When screwing in the gas
Note:
cylinder
, you must wear gloves to
29
protect your hands.
First remove the plastic protective cap
by turning it in a clockwise direction
and pull it off the 0.95 litre argon gas
cylinder
. With the connecting thread
29
aligned with the pressure regulator
place the gas cylinder in the bracket
inside the device which has been
provided for this purpose, see Figure E.
Make sure that the retaining straps
go right round the gas cylinder
However, do not tighten these yet.
Make sure that the switch on the
pressure regulator
position. To do this, turn the regulator on
the pressure regulator in an anti-clock-
wise direction. Now guide the connect-
ing thread of the gas cylinder
inlet of the pressure regulator
connect the inert gas inlet tubing
the quick connector of the pressure reg-
ulator
. To do this push the inert gas
27
inlet tubing
into the quick connector
13
of the pressure regulator
into place. Rotate the gas cylinder
shown in Figure E, in order to connect
it to the pressure regulator
fixing the pressure regulator
leak for a short time. The gas will stop
leaking once it has been connected
properly. In order to make a solid
connection, undo the bracket screw
of the pressure regulator
sary. Now screw the pressure regulator
onto the gas cylinder
14
14
30
.
29
is set to the "Off"
14
to the
29
. Then
14
to
13
until it clicks
27
29
. When
14
gas will
14
28
, if neces-
14
while
29
Welding with flux-cored wire
holding the gas cylinder
are firmly connected together and there
is no gas leak. When doing this, grip
the bracket of the pressure regulator
and not the pressure regulator
in order to avoid any damage. Rotate
the pressure regulator
cylinder
(which are now connected),
29
until the pressure regulator
in a vertical position and re-tighten the
bracket screw
tor
. Now fix the gas cylinder
14
tightening the retaining strap
Remove the gas cylinder
device once the welding work is complete.
z Adaptation of device to
,
flux-cored welding wire
with inert gas
The correct connections for welding with
flux-cored wire when using inert gas are
shown in Figure U.
U
7
as
First connect the plug
connector marked with the "+" (see
Figure U) and rotate it in a clockwise
direction to fix it in place. If you are
in any doubt, then please contact a
professional.
Then connect the earth cable
the corresponding connector, marked
, until they
29
14
and the gas
14
is back
14
of the pressure regula-
28
29
.
30
from the
29
with the
9
GB/IE
26
itself,
by
6
9
with
6
47

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 332971_1907

Inhaltsverzeichnis