Parkside PSGS 120 A1 Bedienungs- Und Sicherheitshinweise Seite 4

GB IE
Correction to the chapters:
z "Welding with flux-cored wire" chapter under
the section "Inserting the flux-cored wire"
The torch nozzle
„
direction during assembly and disassembly and not, as
described in the user instructions, in an anti-clockwise
direction.
z "Welding with flux-cored wire" chapter under
the section "Fit the gas cylinder" and under
the section Adaptation of device to flux-cored
wire welding with inert gas"
Before you connect the gas cylinder
„
regulator
14
regulator is set to the "OFF" position. To do this rotate
the regulator of the pressure regulator in a clockwise
direction and not, as described in the user instructions,
in an anti-clockwise direction.
To increase the gas flow, rotate the regulator of the
„
pressure regulator in an anti-clockwise direction towards
the "ON" position and not, as described in the user
instructions, in a clockwise direction. The "ON" and
"OFF" positions are shown correctly on the regulator of
the pressure regulator.
must be rotated in a clockwise
37
make sure that the regulator of the pressure
Please note
to the pressure
29