Before Use Assembly; Assembling The Welding Mask; Inserting The Flux-Cored Wire - Parkside PFDS 120 A2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

z Before use
Take all parts from the packaging and
„
check whether the flux cored wire welder
or parts show any damage. If this is the
case, do not use the flux-core wire wel-
ding device. Contact the manufacturer
via the indicated service address.
Remove all protective films and other
„
transport packaging.
Check that the delivery is complete.
„
The welding nozzles can be stowed
„
away in the storage compartment for
welding nozzles
z Assembly
z Assembling the welding
mask
Place the dark welding glass
„
mask with the writing on the top
Fig. C). The writing on the dark welding
21
glass must now be visible from the
front of the welding mask.
Push the handle 22
„
the corresponding notch of the mask, un-
til it snaps into place (see Fig. D).
z Inserting the flux-cored
wire
Always unplug the mains
plug from the mains socket prior to each
maintenance task or preparatory work in
order to prevent the risk of an electric shock,
injury or damage.
Note: Different welding wires will be nee-
ded depending on the application. Welding
wires with a diameter of 0.6 – 1.0 mm can
be used with this device.
Feed roll, welding nozzle and wire cross
section must be compatible with one another.
The device is suitable for wire reels weighing
up to maximum 1000 g.
.
26
21
into the
20
(see
from the inside into
Unlock and open the cover of the wire
„
feed unit 1 by raising the threaded rod
along the elongated hole.
Unlock the roller unit by turning the roller
„
29
mount anti-clockwise (see Fig. F).
Pull the roller mount
„
Fig. F).
Note: Make sure that the end of the wire
does not come loose and cause the roll to
roll out on its own. The end of the wire may
not be released until during assembly.
Completely unpack the flux-cored wire
„
welding reel 17 , so that it can unrolled
without difficulty. Do not release the wire
end yet (see Fig. G).
Place the wire reel on the shaft.
„
Make sure that the roll unwinds on the
31
side of the wire feed guide (see Fig.
G).
Place the roll mount
„
it by pressing and turning it clockwise
(see Fig. G).
Undo the adjustment screw
„
it upwards (see Fig. H).
Turn the thrust roller unit
„
(see Fig. I).
Loosen the feed roll holder
„
it anti-clockwise and pull it upwards and
off
(see Fig. J).
On the top of the feed roll
„
whether the appropriate wire thickness
is indicated. If necessary, the feed roll
has to be turned over or replaced. The
supplied welding wire (Ø 0.9 mm) must
be used in the feed roll
cified wire thickness of Ø 0.9 mm. The
wire must be positioned in the upper
groove!
Put on the feed roll holder
„
screw clockwise direction.
Remove the torch nozzle
„
and turning it clockwise (see Fig. K).
Unscrew the welding nozzle
„
K).
Guide the hose package
„
GB/IE/NI/CY/MT
Before use / Assembly
29
off the shaft (see
29
back on and lock
27
and swing
28 to the side
30 by turning
19
, check
19
with the spe-
30 again and
9 by pulling it
15
(see Fig.
12
away from
17