Herunterladen Inhalt Inhalt Diese Seite drucken

Emc Device Classification; Before Use - Parkside PFDS 120 A2 Originalbetriebsanleitung

Fülldraht-schweissgerät
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Safety notes / Before use
or reflecting radiation at least
up to head height, e.g. by a
suitable coating.
z EMC device classification
As per the standard IEC 60974-
10, this welding device is a
welding unit with class A electro-
magnetic compatibility. Thus, it
complies with the corresponding
requirements for industrial and
domestic use. In residential areas,
it can be connected to the public
low-voltage supply systems.
Even if the flux cored wire wel-
der complies with the emission
limit values of the standard, arc
welding devices can still result in
electromagnetic interferences in
sensitive systems and devices.
The user will be held responsible
for any interference caused by
the electric arc during welding
and must also take appropriate
safety measures. In doing so, the
user must observe the following:
– network, control, signal and
telecommunication lines
– computers and other micropro-
cessor-controlled devices
– TVs, radios and other playback
devices
– electronic and electrical safety
equipment
16
GB / IE / NI
– people with cardiac pace-
makers or hearing aids
– measurement and calibration
devices
– interference immunity of other
equipment nearby
– the time at which the welding
work is carried out.
The following is recommended
to reduced possible interference
radiation:
– equip the mains connection
with a
mains filter
– regularly maintain the flux
cored
wire welder and keep it in a
good condition
– welding cables should be
completely uncoiled and run as
close to parallel with the floor
as possible
– devices and systems that are
compromised by the interferen-
ce radiation must be removed
from the welding area or shiel-
ded.
z Before use
Take all parts from the packaging and
check whether the flux cored wire welder
or parts show any damage. If this is the
case, do not use the flux-core wire wel-
ding device. Contact the manufacturer
via the indicated service address.
Remove all protective films and other
transport packaging.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis