PALSON Caprice Gebrauchsanleitung Seite 28

GB
Important: Never clean the steam wand with an abrasive cloth as it will damage the wand. A steam wand cleaning brush
has been supplied with the espresso coffee maker for use should the wand become blocked. The black cleaning brush
(43) has been designed for use with the steam wand. Insert the cleaning brush into the end of the steam nozzle (44).
If the steam wand remains blocked unscrew the nozzle and remove it from the wand. Clean it again with the brush and
rinse with tap water.
DESCALING
Scale is an accumulation of minerals on a surface that occurs naturally over time in all appliances where water is heated.
Therefore, it will occasionally be necessary to descale the espresso coffee maker. You are advised to descale the
espresso coffee maker every 4-6 months, depending on the frequency of use.
Descaling solution
Use any of the following options when descaling the espresso coffee maker:
- Descaling tablets for espresso coffee makers
- Descaling liquid, or
- Vinegar solution.
Descaling the espresso coffee maker
Note: Make sure that the espresso coffee maker is turned off and the power cord is unplugged.
1. Take out the water tank and rinse to clean. Depending on the descaling solution used:
A. Descaling tablets for espresso coffee makers
Fill the water tank with 1 litre of hot water and place one descaling tablet in the tank.
Reinstall the tank once the tablet has dissolved. This takes about 5-7 minutes.
B. Descaling liquid
Fill the water tank with about 1.5 litres of water, add one capful of descaling liquid and reinstall the tank.
C. Vinegar solution
Fill the water tank with about 1.5 litres of water, add 3 spoonfuls of vinegar and reinstall the tank.
2. If the filter holder is fastened to the water outlet, remove, rinse thoroughly under running water and put to one side.
3. Using a screwdriver, unscrew the screen underneath the water outlet.
4. Remove the screen, washer and screw and put to one side in a safe place.
Important: Take care not to lose the screen, washer and screw after the water outlet has been dismantled.
5. Using a small brush, brush inside and around the water outlet, removing all the coffee particles.
6. Place a large enough container underneath the water outlet.
7. Plug the power cord into a 230-240V AC mains outlet and turn on. Press the power switch to start the machine.
Note: Remember that if the "HEATING" lamp is lit, the espresso coffee maker is adjusting the temperature of the heating
system.
28
Downloaded from www.Manualslib.com manuals search engine