Safety Instructions For The Electrical Connection - RADEMACHER RolloTube S-line Sun DuoFern Original - Betriebs- Und Montageanleitung

8. Safety instructions for the electrical connection

Risk of fatal electric shock when touching
electrical components.
◆ Carry out all installation and connection work only
in an isolated, de-energised state.
◆ Disconnect all phases of the mains power lead and
secure it to prevent any reconnection.
◆ Check that the system is de-energised.
Fixed-installation devices...
...must be equipped on the installation side with a
circuit-breaker for each phase in accordance with
DIN VDE 0700. Switches with a contact opening
width of min. 3 mm can be used as circuit-breakers
(e.g. power switch, power circuit breaker or residual-
current-operated circuit-breaker).
Risk of short-circuit resulting from damaged
cable.
◆ Lay the motor cable (13) so that it cannot be dam-
aged by moving parts of the awning.
◆ The mains connection for the drive may only be
connected with the same conduction type. Con-
sult customer services if necessary.
◆ Seal the wall duct after laying the motor cable (13)
in order to prevent water penetration.
56
DANGER!
WARNING! WARNING!
WARNING! WARNING!
Risk of short-circuit resulting from water in the
event of improper cabling.
◆ Never lay the motor cable (13) vertically upwards
otherwise water may collect on the cable and run
into the motor, leading to damage.
◆ Lay the cable in a loop. The loop will cause any
water on the cable to collect at the lowest point,
from where it can drain off.
EN