Reloading The Factory Settings - RADEMACHER RolloTube S-line Sun DuoFern Original - Betriebs- Und Montageanleitung

11. Reloading the factory settings

Self-learning mode with a smooth stop is active
again after loading the factory settings.
Notes for carrying out the setting
◆ Either use a new commercially available universal
setting cable (20).
◆ The tubular motor may not be in operation.
When using the universal setting cable (20)
1.
Button 3 - ON/SET
First, switch on the continuous phase.
2.
Button 1 - switch on the desired direction of
travel ( I or II)
> while simultaneously (within one second) press-
ing and holding
Button 2 (set button III), until the tubular motor
confirms this by briefly running up and down (ap-
prox. 5 seconds).
After that the factory settings are loaded.
Subsequently:
◆ Release Button 2 (set button III)
◆ Button 1 (I/II) in the middle position
◆ Switch off continuous phase - Button 3 (ON/SET)
3.
Switch off the mains power supply and reset the
original connection in accordance with the con-
nection diagrams [ 23 to 25 ] on pages 58 and
59 if you have carried out the setting with the
universal setting cable.
64
Factory settings:
End points:
Self-learning mode:
Blockage detection:
Obstacle detection:
Jog mode using a
1-pole button:
Fabric relief and
Fabric tensioning :
ON/
SET
+
III
I II
or
EN
no end points stored
activated
activated
activated
deactivated
activated
5 sec.