RADEMACHER RolloTube S-line Sun DuoFern Original - Betriebs- Und Montageanleitung Seite 38

i
Contents
1. This manual... ............................................39
2. Hazard symbols .........................................39
2.1 Levels of danger and signal words ......39
2.2 Symbols and depictions used ...............39
3. Safety instructions ....................................40
3.1 Intended use / operational
conditions .....................................................41
3.2 Improper use ...............................................41
3.3 Required expert knowledge of
the installer ..................................................41
3.4 Glossary - Definition .................................42
4. Scope of delivery for RolloTube S-line Sun
DuoFern Medium ......................................43
5. General view of the RolloTube S-line Sun
DuoFern .....................................................44
6. Functional description ..............................45
6.1 Function of the fabric relief and
blockage detection system ....................46
6.2 Function of the fabric tensioning
and obstacle detection system .............46
6.3 Jog mode with one push button .........47
6.4 Operation using a switch ........................47
6.5 Jog mode using a 1-pole button ..........47
6.6 Activating the tubular motor using
the DuoFern radio code ..........................48
7. Important installation instructions .........49
7.1 Preparation of the awning system.......50
7.2 Mounting / dismantling the
adapter (8) ....................................................50
7.3 Dismantling the catch (10) .....................51
7.4 Mounting the catch (10) with the
freewheel mechanism..............................51
7.5 Sliding the tubular motor (9) into
the awning shaft (11) ...............................52
7.6 Preparation for use of the precision
tubes ...............................................................52
7.7 Mounting the drive bearing (4) ............54
7.7.1 The drive bearing as a click
7.7.2 Mounting in other drive
7.8 Preparing the awning for electrical
connection and commissioning...........55
38
bearing (4) ........................................54
bearing versions ............................54
8. Safety instructions for the electrical
connection .................................................56
8.1 Safe cable routing by fixing the
plug connection .........................................57
8.2 Connecting the motor cable (13) .........57
8.3 E lectrical connection of the tubular
motor .............................................................58
8.3.1 Controlling the tubular motor
via radio ............................................58
8.3.2 Controlling the tubular motor
using a switch or a push
button ................................................58
8.3.3 Controlling the tubular motor
using a 1-pole button (closer) ...59
8.3.4 Parallel connection of
several motors ................................59
8.4 Connection of the universal setting
cable for manual end point setting .....60
9. Self-learning mode ...................................61
10. Manual adjustment of end points ...........61
10.1 Test run / modifying the end points ...63
11. Reloading the factory settings .................64
12. What to do if... ? .........................................65
13. Technical specifications ............................66
14. Configuration of KNX/EIB actuators
for RADEMACHER tubular motors ...........66
15. Simplified EU declaration of
conformity .................................................67
16. Logging DuoFern devices on/off..............68
16.1 Logging a DuoFern device on/off
using the set button .................................68
16.2 Logging a DuoFern device on/off
using a switch/button or
universal setting cable .............................69
16.3 Activating log-on mode using the
remote log-on function ...........................70
17. Warranty terms and conditions ...............71
EN