Electrical Connection Of The Tubular Motor; Controlling The Tubular Motor Via Radio; Controlling The Tubular Motor Using A Switch Or A Push Button - RADEMACHER RolloTube S-line Sun DuoFern Original - Betriebs- Und Montageanleitung

8.3 Electrical connection of the tubular motor

8.3.1 Controlling the tubular motor via radio

Legend:
= Set button (7)
(a)
= Socket box
(b/d)
= Mains 230 V/50 Hz
(c)
Pin assignment:
= PE
(e)
= N
(f)
= L
(g)
=
(h)
=
(i)
* The black and brown wires (direction of travel 1 and 2) are not
required for radio operation and therefore not connected.

8.3.2 Controlling the tubular motor using a switch or a push button

Legend:
= Set button (7)
(a)
= Switch or push button
(b)
= Mains 230 V/50 Hz
(c)
= Socket box
(d)
Pin assignment:
= PE
(e)
= N
(f)
= L
(g)
=
(h)
=
(i)
When using a switch, we recommend that the mains power to the motor is switched off (switch in zero po-
i
sition) after reaching the end points. This avoids the motor experiencing sources of interference or excess
voltages.
58
green/yellow
blue
grey (continuous phase )
black (direction of travel 1) *
brown (direction of travel 2) *
green/yellow
blue
grey (continuous phase )
black (direction of travel 1) *
brown (direction of travel 2) *
23
(a)
5
(b) (d)
3
(c)
24
(a)
5
(b) (d)
3
(c)
Example: Circuit layout with a push button
EN
(e) (f) (g) (h) (i)
L
N
PE
(e) (f) (g) (h) (i)
L
N
PE