Self-Learning Mode; Manual Adjustment Of End Points; Initial Installation - RADEMACHER RolloTube S-line Sun DuoFern Original - Betriebs- Und Montageanleitung

9. Self-learning mode

The RolloTube S-line Sun DuoFern is delivered
from the factory in self-learning mode and can be
put into operation immediately after the electrical
connection.
1.
Switch on the mains power supply. When using the
universal setting cable, press the On/Set button.
The RolloTube S-line Sun DuoFern is ready for
operation immediately.
2.
First extend and then retract
▲ ▼
the awning.
The end positions are automatically
learned during the first run cycles.
3.
Subsequently check the direction of travel, if the
RolloTube S-line Sun DuoFern is being operated
using a switch or button.
Switch the lines for the rotation direction if the
direction of travel is wrong, see connection
diagrams [ 24 / 25 ] on pages 58 / 59 .

10. Manual adjustment of end points

You can also adjust the end points manually
if required:
◆ The manual setting of the outer end point is
done first and then the upper end point setting,
e.g. during the initial installation.
◆ Manual adjustment of an end point in combina-
tion with the self-learning mode.

Initial installation

For initial installation, the awning specialist can carry
out the end point setting with the help of the set
button (7) on the motor or with a commercially
available universal setting cable (20).
In order to do so, follow the more
detailed information provided in the
operating manual of the respective
accessories.
Subsequent modification of the end points with
external controllers
If you want to subsequently modify the end points of
your awning motor, you can adjust these with your
controller (e.g. Troll Comfort).
The processes must not be interrupted
i
while learning the outer end point.
While learning the outer end point, it is
important to note that the awning motor
runs until the fabric hangs loosely and
then moves back automatically until the
fabric is taut again and stops. This is a
sign that the outer end point has been
learned.
Over-dimensioned tubular motors can
i
lead to malfunctions during end point
setting in self-learning mode.
Please monitor the awning closely during
this process. If the motor does not stop
when the fabric is taut again, but the
joint arms fold and retract the awning
again, the motor is over-dimensioned
for the system and the process must be
interrupted. The outer end point must be
set manually in this case.
WARNING! WARNING!
Risk of fatal injury (electric shock) due to tear-
ing off the motor cable (13).
◆ Ensure that the motor cable (13) is not taken up
by the moving awning parts or torn off during
the setting process.
Important conditions for adjusting
the end points and for safe operation
◆ End points must be set in order to switch off the
motor when they are reached for both directions
of travel, retract (▲) / extend (▼).
◆ The tubular motor must be fully installed.
CAUTION!
Risk of injury when adjusting the awning due
to crushing of the hands by the moving awning.
◆ Never reach into the area of the awning shaft (11)
and joint arms (19) when the motor is running.
EN
61