10. Manual adjustment of end points
Reset the original connection in accordance with the connection diagrams [ 23 to 25 ] on pages 58 to 59
if you have carried out the setting with the universal setting cable.
i
In the event that a malfunction occurs during the setting process, e.g. the tubular motor only runs for a
single rotation even when you press and hold the set button, the adapter (8) may have slipped off the
drive head (6).
◆ Check and, if necessary, correct the positioning of the adapter (8), see page 65.
10.1 Test run / modifying the end points
Test run
1.
Subsequently check the direction of travel, if the
RolloTube S-line Sun DuoFern is being operated
using a switch or button.
Switch the lines for the rotation direction if the
direction of travel is incorrect, see connection dia-
grams [ 24 / 25 ] on pages 58 / 59 .
2.
Check the settings and allow the awning to run in
both directions, until the end points switch off the
motor.
The fabric tensioning function is active
i
during the manual end point setting
after the first run cycle.
ATTENTION!
The tubular motors are designed for transient
operation (approx. 4 min.).
If this period is exceeded, or if the equipment is
switched over frequently, then the motor may heat
up and the thermal protection system will switch
it off.
◆ In this case, allow the motor to cool down for
20 minutes.
Modifying the end points
Move the awning back to the centre position and
begin the process again.
EN
63