First Commissioning - Optimum OPTIdrill B 17Pro basic Betriebsanleitung

256
190
Img.3-4: Mounting the foot B17Pro basic
3.4

First commissioning

ATTENTION!
Before initially operating the machine, check all screws, fixtures and/or safety devices
and tighten up the screws if necessary!
WARNING!
Risk from using improper workpiece clamping materials or operating the machine at an
inadmissible speed.
Only use the tool holders (e.g. drill chuck) which were delivered with the machine or
which are offered as optional equipment by OPTIMUM.
Only use tool holders in the intended admissible speed range.
Tool holders may only be modified in compliance with the recommendation of OPTI-
MUM or of the manufacturer of the clamping devices.
WARNING!
There is a danger to persons and equipment, if the first commissioning of the drilling
machine is carried out by inexperienced personnel.
We do not accept any liability for damages caused by incorrectly performed commis-
sioning.
Assembly
Version 1.0 2019-01-17 Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
B17Pro basic
®
GB
Page 49