Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
16
Centrifugation
In accordance with EN / IEC 61010-2-020, no persons, hazardous substances or objects may be within a
safety range 300 mm around the centrifuge during a centrifugation run.
If the permissible weight difference was exceeded within the rotor load, the centrifugation run is aborted during
start-up and the following will appear on the display:
>RCF<
RPM
t/min:s
A centrifugation run can be aborted at any time by pressing the
During a centrifugation run, centrifugation parameters can be selected and changed. The changed values,
however, only apply to the current centrifugation run and are not saved.
RCF
With the
key, you can toggle between the RPM display (RPM) and RCF display ( RCF ) at any time. If
the RCF display ( RCF ) is worked with, the centrifuging radius must be input.
The following is displayed:
>RCF<
RPM
t/min:s
Further operation of the centrifuge is then only possible after opening the lid.
Operation errors and malfunctions will be shown (see the chapter on "Malfunctions").
Switch on the mains switch. Switch position .
Load the rotor and close the centrifuge lid.
16.1
Centrifugation with preset time
Press the key to activate the RPM display
RCF
(RPM) or the RCF display ( RCF ) as
needed.
Enter the desired centrifugation parameters (see the
chapter "Entering centrifugation parameters").
Press the key to start the centrifugation
START
PULSE
run.
During the centrifugation run, the rotor
speed or the resulting RCF value and
remaining time are displayed.
After the time elapses or if the centrifugation run is
STOP
OPEN
aborted by pressing the
occurs with the set brake stage.
The brake stage is displayed. Example
AB1801DEENFRIT
Example:
RPM display (RPM)
>RCF<
>RCF<
>RCF<
>RCF<
key, the run-out
f
Rev. 07 / 05.2020
STOP
OPEN
key.
Example:
RCF display ( RCF )
RPM
t/min:s
>RCF<
RPM
t/min:s
>RCF<
RPM
t/min:s
>RCF<
RPM
t/min:s
>RCF<
EN
RPM
t/min:s
RPM
t/min:s
RPM
t/min:s
RPM
t/min:s
55/134
Werbung
Kapitel
Inhaltsverzeichnis
