Hettliner Packing Instructions; Packing Before Centrifugation - Hettich ROTO SILENTA 630 RS Bedienungsanleitung

EN
16

HettLiner packing instructions

16.1

Packing before centrifugation

Note: Make sure that the plastic insert cannot tip over when loading and unloading the inserts (use loading aid 4509).
a
b
c
d
e

If available, fold empty satellite bag(s) and pack differently depending on the appropriate accessories and
filling volume of the blood bag.
It is a good idea to fold the satellite bags and pack them on the outside between the folded support plate
and the outer wall of the insert.
→ Make sure that the silicone plate does not slip while doing this!
→ If necessary, the silicone plate can be held by the loop when packing the satellite bag and thus held
against it
→ The position of the loop must be checked afterwards!

Place the connections over the support plate so that the valves cannot break.
Make sure the tubes do not protrude from the insert!
→ Stow tube sections protruding over the edge of the insert between the folded down support plate and the
insert wall.

Balance weights should be placed between the folded down support plate and the bucket wall if needed.
60/165

b
a

d
c

e



Rev. 18 / 04.2023
Insert the blood bag (a) into the insert
(b).
Hold the blood bag at the connections
(c) and push the support plate (d) on
the outer side of the blood bag from
top to bottom into the
Make sure that the lower edge of the
support plate rests as completely as
possible on the floor.
Fold the support plate outwards and
push it down until the folded edge of
the support plate is level with the
liquid level of the blood
The position of the loop (e) must be
observed so that it can be reached
after centrifugation!
The upper edge of the support plate
must not protrude too far from the
insert during centrifugation due of the
risk of jamming with the rotor arms!
AB5005DEENFRIT
insert
bag.