Grinding; Changing The Grinding Disc/ Buffing Disc; Fitting The Flexible Shaft - Parkside PDFW 120 A2 Originalbetriebsanleitung

♦ Switch the appliance on by pressing the
ON/OFF switch
♦ Set a speed suitable for the work using the
speed control .
♦ Switch the appliance off by pressing the
ON/OFF switch

Grinding

♦ Place the workpiece on the tool rest
Guide the workpiece slowly towards the
grinding disc at the required angle until the
workpiece and the grinding disc
contact with each other.
♦ Move the workpiece evenly backwards and
forwards in order to achieve optimal results. This
also ensures that the grinding disc
down more evenly.
Changing the grinding disc/
buffing disc
WARNING! RISK OF INJURY!
► Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
WARNING!
► The grinding or buffing disc
not be any larger than the prescribed diameter.
► Replace the grinding
when the outer diameter is less than 50 mm.
NOTE
► Please note that you will require tools which
are not included in delivery for the assembly.
♦ Using a Phillips screwdriver, unscrew the fix-
ing bolts from the side protective covers
(see fig. E). Remove the protective covers
both sides.
♦ If you want to change the buffing disc
screw the attachment for the flexible shaft
♦ Unscrew the union nut
using a 17 mm wrench. Hold the affected
grinding or buffing disc
hand to create a suitable counterpressure.
PDFW 120 A2
.
again.
.
come into
is worn
used may
or buffing disc
, un-
from the shaft
firmly in one
♦ Remove the tension disc
or buffing disc
♦ Place the new grinding
the shaft .
♦ Push the tension disc
♦ Screw the union nut
♦ Re-tighten the union nut
or buffing disc
firmly in one hand to create a suitable counter-
pressure.
WARNING! RISK OF INJURY!
► Never use the grinding
without the protective cover
CAUTION! PROPERTY DAMAGE!
► Do not tighten the union nut
since the grinding disc
break.
♦ Refit the protective cover
by tightening the fixing screws
Fitting the flexible shaft
WARNING! RISK OF INJURY!
►
Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
♦ Screw the flexible shaft
thread of the appliance. To do this, push the
axle core of the flexible shaft into the square
hole on the connecting thread
ing nut anticlockwise to tighten it.
WARNING! RISK OF INJURY!
► Make sure that the eye shields
down to the tool rests
on
unintentional contact with the grinding
buffing disc
► After use, remove the flexible shaft
.
the appliance. Otherwise, the flexible shaft
could start thrashing about in an uncontrolled
manner and cause an injury when you switch
the appliance on.
and grinding
.
or buffing disc
back onto the shaft
back onto the shaft
. Hold the grinding
that you have just attached
or buffing disc
.
too tightly
could otherwise
and fix it in place
.
onto the connecting
. Turn the lock-
are folded
. This can prevent
.
GB │ MT │
on
.
.
or
from
73 ■