General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PDFW 120 A2 Originalbetriebsanleitung

Explanation of the symbols used on
the appliance
■ Read all safety warnings
and all instructions!
■ Read all safety warnings
and all instructions!
■ Wear safety goggles!
■ Wear hearing protection!
■ Wear protective gloves!
Noise emission value
Noise measurement value determined in accord-
ance with EN 62841-3-4. The rated noise level of
the power tool is typically:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear hearing protection!
NOTE
► The noise emission values given in these
instructions have been measured in accord-
ance with a standardised test procedure and
can be used for comparison of the power
tool with another tool.
► The specified noise emission values can also
be used to make a provisional load estimate.
WARNING!
► Depending on the manner in which the power
tool is being used and, in particular, the kind
of workpiece being worked, the noise emis-
sion values can deviate from the values given
in these instructions during actual use of the
power tool.
► Try to keep the vibration load as low as
possible. Measures to reduce noise emissions
include ear muffs and limiting the working
time. Wherein all states of operation must be
included (e.g. times when the power tool is
switched off and times where the power tool
is switched on but running without load).
│ GB │ MT
■ 64
L = 86.2 dB (A)
pA
K = 3 dB
pA
L = 99.2 dB (A)
WA
K = 3 dB
WA
General Power Tool
Safety Warnings
WARNING!
► Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of flam-
mable liquids, gases or dust. Power tools cre-
ate sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.

2. Electrical safety

a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded)
power tools. Unmodified plugs and matching
outlets will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of elec-
tric shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
PDFW 120 A2