Adjusting The Tool Rests; Fitting The Spark Deflectors; Fitting The Eye Shields; Working Procedures - Parkside PDFW 120 A2 Originalbetriebsanleitung

Adjusting the tool rests

♦ Adjust the workpiece rests
the knurled screws
between the grinding
and the tool rest
Ensure that the workpiece rests
into contact with the grinding
discs .
♦ Adjust the distance repeatedly as the
grinding or buffing disc
Fitting the spark deflectors
♦ Fit the spark deflectors
fixing bolts for the spark deflectors
washers and spring washers to the top of the
device (see fig. C).
♦ Tighten the nuts using a pair of pliers or a 7 mm
open end wrench. Tighten the fixing bolts for
the spark deflector
driver.
♦ Fit the spark deflectors
between the grinding
the spark deflector
The gap should not be greater than 2 mm.
Ensure that the spark deflectors
into contact with the grinding
discs .
♦ Adjust the distance repeatedly as the
grinding or buffing disc

Fitting the eye shields

♦ Attach the eye shields
on the spark deflectors using the mounting
screws for the eye shields
spring washers (see fig. C).
♦ Tighten the nuts using a pair of pliers or a 8 mm
open end wrench. Tighten the fixing bolts for
the eye shields using a screwdriver.
│ GB │ MT
■ 72
with the aid of
. Ensure that the space
or the buffing disc
is as low as possible.
do not come
or the buffing
wears down.
with the aid of the
, nuts,
using a Phillips screw-
so that the distance
or buffing disc
is as small as possible.
do not come
or the buffing
wears down.
to the fixtures provided
, nuts, washers and

Working procedures

Ensure that the appliance is always stable
and secure. For extra safety, you can secure
the appliance in a suitable location. There are
4 drill holes
be used for attachment to a secure and level
surface. Feed a suitable fixing material that
is appropriate for the surface (not supplied)
through the 4 drill holes
to the surface using the fixing material.
Ensure that the grinding
discs are not blocked.
Ensure that the eye shields
tors and tool rests
and adjusted!
A light grinding pressure is sufficient
Work using a light grinding pressure – a constant
and correct speed will ensure the best grinding
performance.
Grinding
Bear in mind that the workpiece heats up during
grinding. Therefore, cool the workpiece in a water
and
bath. Dry it thoroughly before you resume working.

Operation

Switching on and off
■
NOTE
► Before first use, allow the grinding
buffing discs
speed for about 5 minutes. When doing so,
stay out of the hazard area in front of and
next to the openings in the grinding
buffing disc
WARNING! RISK OF INJURY!
► Ensure the lowest-possible distance (gap)
between the grinding
disc and the tool rest
► If the appliance suddenly brakes completely
or jams, it must be switched off immediately.
♦ Set the eye shields
greatest possible protection.
in the housing foot that can
. Fix the appliance
and buffing
, spark deflec-
are properly fitted
Direction of rotation of the tool!
to run without a load at top
.
or the buffing
.
so that they provide the
PDFW 120 A2
and
or the