Special Safety Instructions For Grinding And Cutting; Other Special Safety Instructions For Cutting Grinding - Parkside PWSA 12 B1 Originalbetriebsanleitung

GB CY
c) Keep your body away from the area in
which the electric tool would move dur-
ing a kickback. The kickback drives the
electric tool in the counter-direction to
the rotation of the grinding disc at the
blocked spot.
d) Work particularly cautiously in corner
areas or where there are sharp cor-
ners etc. Prevent the attachment tools
from recoiling from the workpiece and
jamming. The rotating attachment tool
tends to jam when near corners, sharp
edges or when it recoils from such. This
causes a loss of control or kickback.
e) Do not use chain or toothed saw
blades. Such attachment tools frequent-
ly cause a kickback or loss of control
over the electric tool.
Special safety instructions for
grinding and cutting
a) Use only grinders which have been
approved for your electric tool and
the protective hood intended for these
grinders. Grinders which are not in-
tended for the electric tool may not be
sufficiently shielded and are unsafe.
b) Depressed Center grinding wheels
must be pre-assembled so that their
surface not above the level of the edge
of the guard stands out. An improperly
mounted grinding wheel, which ex-
tends beyond the level of the edge of
the guard, not sufficiently shielded.
c) The protective hood must be securely
attached to the electric tool and adjust-
ed so that the greatest level of safety
is reached, i.e., the smallest possible
amount of the grinder is exposed to the
operator. The protective hood should
protect the operator from broken bits
and accidental contact with the grinder.
d) Grinders may only be used for the
12
recommended attachment options. For
example: Never grind with the side
surface of a cutting disc. Cutting discs
are for cutting material using the edge
of the disc. Pushing sideways on these
grinders can break them.
e) Always use undamaged clamping
flanges of the correct size and shape
for the grinding disc you selected.
Suitable flanges support the grinding
disc and thus reduce the danger of the
grinding disc breaking. Flanges for
cutting discs can be distinguished from
flanges for other grinding discs.
f) Do not use worn grinding discs for
larger electric tools. Grinding discs for
larger electric tools are not set up for
the higher rotation speeds of smaller
electric tools and can break.
Other special safety instructions for
cutting grinding
a) Avoid blocking the cutting disc or
pressing down too hard. Do not make
any excessively deep cuts. Overload-
ing the cutting disc increases wear and
its tendency to tilt or block and, with
that, to kickback or break the grinder.
b) Avoid the area in front of and behind
the rotating cutting disc. When you
move the cutting disc by itself in the
workpiece, in the event that the electric
tool kicks back with the rotating disc, it
can spin directly towards you.
c) If the cutting disc jams, or you interrupt
your work, switch the device off and
hold it until the disc has come to a full
stop. Never try to pull the cutting disc
out of the cut while it is still running,
because it can kick back. Identify and
correct the cause of the jamming.
d) Do not switch the electric tool on again
as long as it is in the workpiece. Al-