6.4 Caster trailing adjustment
After the rear wheels have been mounted in the appropriate position, the caster wheel journal
angle must be readjusted. The threaded axle should be as horizontal as possible in relation to
the ground to ensure optimal driving behaviour of the wheelchair. The caster adapter allows for
continuous angle adjustment.
Remove the cap from caster head bearing with a screwdriver .
Loosen the rear screw connection as shown in fig. 43.
Open the screw connection of the eccentric. Place the bubble level on the caster wheel journal
and adjust the eccenter with a screwdriver . Retighten all screw connection and put on the cover
caps.
INFORMATION
Motus CV/CS
Downloaded from
www.Manualslib.com
The proper torque for tightening the screws is 8 Nm.
manuals search engine
41
43
Adjustment/Assembly instructions
42
44
Ottobock | 63