Training Stand-By; Performance (Fixed); Current Default Settings - Kettler SE1 Bedienungsanleitung

Training stand-by

The display is structured as follows.
This display shows the values and settings.
Display:
First line
Active user = Thomas
Active programme = Performance (manual) Count Down
Current pulse = 70 bpm
Current pulse ratio = 41% (current pulse to maximum pulse)
Current date and time
Second line
Display:
Current pedal rate = 0 min-1
Current speed = 0.0 km/h
The following was adopted from the default setting
"Thomas":
Distance = 7.50 km
The following was adopted from the default setting
"Thomas":
Energy consumption = 800 kJoule
10
GB
Display: Third line
The following was adopted from the default setting
"Thomas": Training time = 30:00 min
Display: Fourth line
Default setting Performance = 25 Watt
Current performance ratio = 4% (current performance to
the preset
appliance maximum performance.)
Display: 5 only for appliances with height adjustment.
Display: Multi-purpose display
In the "Training stand-by" the current programme is dis-
played here.
By pressing "Users" you will skip to the menu "Users"
By pressing "Programmes" you will skip to the menu
"Programmes"
By pressing "Current Default Settings" you will skip to
the menu "Current Default Settings" and the default settings,
which are to be entered or have already been entered at the
"active" programme.
Note:
The performance can be increased or decreased by 50 Watt
by means of the navigation keys or by 5 Watt by means of
the- / + keys during training stand-by or training.
1b
Selecting a training programme with performance profile: e.g.
Performance (fixed) Programme 1
By pressing "Default Settings", you will skip to the menu
"Current Default Settings" and the default settings, which are
to be entered or which have already been entered at the
"active" programme are displayed.
Display:

Current default settings

Mode =
Programme length =
Max. pulse (selected)
Alarm at exceeding the maximum pulse =
Here the default settings are the values, which the active user
"Thomas" entered beforehand under "Default Settings ->
Pulse default settings:
Programme Mode Time or Distance
Pressing "- /+" will switch the mode of the programme from
time to distance. Under programme length, you can adjust the
time from 20 - 120 minutes and the distance from 8 kilomet-
res to 48 kilometres (cross ergometer 24 kilometres).
Display: Current default settings
Mode =
Programme length =
By pressing "Train" you will adopt the values and settings
and you skip to the view "Training stand-by".
time
30 min
170 bpm
on
Distance
12.0 km