Cleaning And Maintenance; Cleaning - Parkside PSBS 240 C2 Originalbetriebsanleitung

• Always reassemble the device
completely after replacing the
grinding disc.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when
changing the grinding discs in or-
der to avoid cutting damages.
1. Remove the spark protection (
1) (see „Assemble/set spark pro-
tection).
2. Loosen the 3 fixing screws (15)
and remove the grinding disc
cover (16).
3. Loosen the fixing screws
( 11) and remove the grinding
belt cover (
ing the grinding belt").
4. Unscrew the grinding disc nut
(19a) in the clockwise direction,
by holding the nut of the opposite
roller of the grinding belt in place
(see small image). Hold it tight
with a 19mm socket wrench or
pliers.
5. Remove the clamping flange
(19b) and the grinding disc (19).
6. Set up the new grinding disc (19)
and the clamping flange and man-
ually screw the grinding disc nut
(19a) in the anti-clockwise direction.
7. Screw the grinding disc cover (16).
8. Set the spark protection (
and the workpiece support (
18) so that the distance between
the grinding disc (19) is max.
2 mm (see „Assembly").
12) (see „Chang-
1)
GB
The grinding disc nut must not be
screwed too tightly in order to avoid a
breaking of the grinding disc and nut.
9. Test run: Before starting work
and after each change of grind-
ing disk, carry out a test run of at
least 60 seconds with no load.
Switch off the equipment im-
mediately if the disk runs lumpy,
substantial vibrations occur, or
abnormal noises are generated.
Cleaning and
maintenance
Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described
in these instructions carried
out by a specialist workshop.
Use only original components.
Allow the equipment to cool
before carrying out any main-
tenance and cleaning work.
There is a risk of burns.
Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
In particular, check the grinding
disk ( 19). Replace damaged parts.

Cleaning

Do not use cleaning agents or sol-
vents. Chemical substances may at-
tack plastic parts of the equipment.
Never clean the equipment under
running water.
IE NI CY
13