Further Safety Instructions - Parkside PSBS 240 C2 Originalbetriebsanleitung

GB IE NI
• Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the pow-
er tool in unexpected situations.
Maintain tools with care.
•
Many accidents are caused by poorly
maintained power tools.
- Keep cutting tools sharp and clean
for better and safer performance.
- Follow instruction for lubricating and
changing accessories.
- Inspect tool cords periodically and if
damaged have them repaired by an
authorized service facility.
- Inspect extension cords periodically
and replace if damaged.
- Keep handles dry, clean and free
from oil and grease.
• Disconnect tools. When not in use,
before servicing and when changing
accessories disconnect tools from the
power supply. Such preventive safety
measures reduce the risk of starting the
power tool accidentaIly.
• Remove adjusting keys and
wrenches. Form the habit of checking
to see that keys and adjusting wrenches
are removed from the tool before turn-
ing it on. A wrench or a key left at-
tached to a rotating part of the power
tool may result in personal injury.
• Avoid unintentional starting.
Ensure switch is in "off" position when
plugging in.
• Use outdoor extension leads.
When the tool is used outdoors, use
only extension cords intended for out-
door use and so marked.
• Stay alert, watch what you are
doing and use common sense
when operating a power tool.
Do not use a power tool while you are
tired or under the influence of drugs,
alcohol or medication. A moment of in-
8
CY
attention white operating power tools
may result in serious personal injury.
Check damaged parts. This will
•
ensure that the safety of the power tool
is maintained.
- Before further use of tool, it should
be carefully checked to determine
that it will operate properly and per-
form its intended function.
- Check for alignment of moving parts,
binding of moving parts, breakage of
parts, mounting and any other condi-
tions that may affect its operation.
- A guard or other part that is dam-
aged should be properly repaired or
replaced by an authorized service
centre unless otherwise indicated in
this instruction manual.
- Have defective switches replaced by
an authorized service centre.
- Do not use the tool if the switch does
not turn it on and off. There is a risk
of injury.
• Warning.
The use of any accessory or attach-
ment other than one recommended in
this instruction manual may present a
risk of personal injury.
• Have your tool repaired by a
qualified person. This electric tool
complies with the relevant safety rules.
Repairs should only be carried out by
qualified persons using original spare
parts, otherwise this may result in con-
siderable danger to the user.

Further Safety Instructions

• Connect the device only to a power
point with a RCD (Residual Current De-
vice) with a measured residual current
of not more than 30 mA.
• Keep power cords and extension cords
away from the grinding disc In the