Gas Specification Table - Pitco frialator SG14 Installations- Und Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für SG14:

Inhaltsverzeichnis

Verfügbare Sprachen

Country GB (Great Britain)

Appliance

Model

Number

SG14

NAT

G20

G31

SG14R

NAT

G20

G31

SG14T

NAT

G20

G31

SG18

NAT

G20

G31

SG14C

NAT

G20

G31

1) Following the Fryer Start-up and Shut Down instructions following in this manual, shut the appliance off and

allow the appliance to cool to room temperature. Insure that gas supply shut-off valve (located on the gas supply

pipe before the fryer operating gas valve) is in the "OFF" position. Remove main burners.

2) Remove all burner orifices and replace them with the appropriate orifices for the new gas type (refer to Table 1

for proper orifice size, that will match gas type conversion). Make sure that an approved gas sealant is applied to

the orifice threads before installing the orifices to the main burner manifold (remove burners if necessary to

replace orifices).

NOTE: If unit is being converted from LP to Natural gas or Natural to LP gas, the pilot orifice and regulator (on

gas valve) must also be replaced with appropriate orifice and gas type regulator.

3) If burners were removed, reinstall them and turn gas supply shut-off valve to the "ON" position. Refer to lighting

instructions and relight the appliance. With burners on, check for any gas leakage around the orifices.

4) With main burners operating, check burner manifold pressure and insure that proper gas pressure is supplied to

the burner system (refer to Table 2 for pressure settings). Adjust if necessary.

5) Finally, apply the gas type conversion label, provided with the conversion kit, just below the fryer data plate on

the fryer door inside panel.

Table 1 Orifice Tips

Model

G20

SG14

#41

SG14R

#39

SG14T

#43

SG18

#41

KC14

#43