Pitco frialator SG14 Installations- Und Bedienungsanleitung Seite 2

THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE
DO NOT ATTEMPT TO MAKE ADJUSTMENTS TO SEALED DEVICES, THEY
HAVE BEEN SET AT THE FACTORY AND DO NOT REQUIRE FURTHER
INSTALLATION AND ALL CONNECTIONS MUST BE MADE ACCORDING TO
Post in a prominent location the instructions to be followed in the event that an operator smells gas. Obtain this
information from your local gas supplier.
Wait 5 minutes before attempting to relight the pilot to allow for any gas in the fryer to dissipate.
A cooker equipped with casters and a flexible gas line, must be connected to the gas supply with a quick
disconnect device. This quick disconnect must be installed according to national/local requirements. To limit the
movement of the cooker without depending on the connector or quick disconnect, a restraining cable must also be
installed.
Installation should be done by a Competetent Service Technician.
The Model & Serial Number, and the Gas Type & Pressure are stamped into the
This appliance is intended for professional commercial use only and, as such, should
It is recommended that this machine be inspected by a Qualified Technician on a yearly basis.
The power supply must be disconnected before servicing or cleaning the appliance
Fryer is equipped with a high temperature safety shut-off switch, which will stop the heating operation
if shortening temperature exceeds 425
WARNING
ADJUSTMENTS
WARNING
NATIONAL AND LOCAL CODES IN FORCE.
TO THE PURCHASER
WARNING
DO NOT use an open flame to check for gas leaks!
WARNING
WARNING
NOTICE
Data Plate, located on the inside panel of the door.
NOTICE
be operated by fully trained personnel.
NOTICE
WARNING
HIGH LIMIT RESET
0 F (202 0 C ). If fryer does not heat press reset button, if unit still
does not heat call authorized service agent.
i