Comparative Measurement Table (Only With Thermocouples); Tare Function - WIKA DI35-M Betriebsanleitung

7. Description of program numbers

7.1.5 Comparative measurement table (only with thermocouples)

The comparative measurement table can only be parameterised with thermocouples
(PN0 = 21 ... 29)
PN Function
6 Comparative measurement table
A deactivation can be useful when the transfer point is maintained at a
very constant level via controlled terminal heating. In such a case, the
cabling to the measuring instrument can be made with simple copper
cable.

7.1.6 TARE function

The TARE function sets the display value to the set value of the taring. The difference
between the set point and the display value is stored as an offset value (PN5).
The TARE function overrides a previously programmed offset shift (PN5).
Should the TARE function be used during a measurement, the offset shift
has to be reprogrammed.
The TARE function can be activated through the following points under PN8.
PN Function
7 Set value for the taring
8 Trigger for taring
WIKA operating instructions digital indicator, model DI35-M
Parameter
0 = deactivated
1 = activated
Parameter
-9999 ... 99999
00 = none
01 = digital input
02 = multi-function button
03 = digital input without button
04 = system start
05 = combination 1 + 4
06 = combination 2 + 4
07 = combination 3 + 4
08 = temporarily via digital input
09 = quickly via digital input
10 = quickly via multi-function button
11 = quickly via multi-function button
and digital input
EN
27