Transport, Packaging And Storage; Transport; Packaging And Storage - WIKA DI35-M Betriebsanleitung

4. Transport, packaging and storage

4. Transport, packaging and storage

4.1 Transport

EN
Check the digital indicator for any damage that may have been caused by transport.
Obvious damage must be reported immediately.

4.2 Packaging and storage

Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).
Permissible conditions at the place of storage:
Storage temperature: -20 ... +80 °C
■
Humidity: 0 ... 75 % relative humidity (no condensation)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Store the digital indicator in its original packaging in a location that fulfils the conditions
listed above. If the original packaging is not available, pack and store the instrument as
described below:
1. Wrap the instrument in a plastic film.
2. Place the instrument, along with shock-absorbent material, in the packaging.
12
CAUTION!
Damage through improper transport
With improper transport, damage to property can occur.
▶
When unloading packed goods upon delivery as well as during internal
transport, proceed carefully and observe the symbols on the packag-
ing.
▶
With internal transport, observe the instructions in chapter 4.2
"Packaging and storage".
WIKA operating instructions digital indicator, model DI35-M