Firmwareupdate - HBM PACEline CMD600 Bedienungsanleitung

CMD600
10

Firmwareupdate

The firmware used in the CMD600 can be read when the CMD600 is
connected, using the CMD Assistant in the dialog: Device − > Identification −
> Firmware Version.
If it is necessary to install new firmware due to new or improved functions, the
latest firmware version can be obtained as a download at the following
address:
http://www.hbm.com/download/firmware
The device settings remain unchanged if the firmware is updated. However,
we recommend that all settings be saved via the CMD Assistant to the PC
before an update.
Preparations for updating the firmware:
• In the operating mode 'Firmware update', all CMD600 amplifiers have a
limited IP Stack and the same Mac and IP addresses.
• A firmware update is only possible for one device at a time (in the same
network).
• The permanent IP address of the CMD600 for firmware updates is:
10.60.250.78 and cannot be changed.
• Connect the PC with the CMD Assistant and the CMD600
• Change the IP address of the PC so that it matches the address range
10.60.250.78 of the CMD600 (e.g. 10.60.250.10). The PC settings can be
checked with the command "ipconfig".
• Copy the firmware update program "ethFlash", together with the new
firmware, into a directory on your PC
Procedure for firmware update:
• Please start the application 'Firmware update' before activating the Boot
Loader. The 'Firmware update' application has 3 parameters. An empty
space must lie between each parameter:
• File name of firmware − name_of_hex_file.hex
• Permanently assigned IP address − 10.60.250.78
• Parameter 'Erase' − e
• Switch the CMD600 off, apply a voltage of 12−30 V
input, and then switch it on again (Pin 2 pn the System input/output
connector plug (brown wire color in system cable)).
A2781−2.1 en/de/fr
to the "SensorTech"
DC
35