Clean The Rear Air Filter; Clean The Side Air Filters (Everest 600 Only) - Rimage Everest III Benutzerhandbuch

Rimage Everest™ III and 600 User Guide
3. Inside the printer, use the sponge swab to wipe tacky roller 2.
4. Prepare the printer for use.
a. Install the print ribbon carrier.
b. Close all latches.
c. Close the side cover.
The printer is ready for use.

Clean the Rear Air Filter

#
Tool Required: Phillips #2 screwdriver
1. Remove the air filter.
a. At the rear of the Everest printer, remove the two
screws (Qty. 2) that hold the fan cover.
b. Remove the fan cover.
c. Remove the air filter.
2. Clean the air filter.
a. Hold the air filter under running water.
Allow the air filter to dry.
b.
3. Prepare the printer for use.
a. When the air filter is dry, place it inside the fan cover.
b. Insert the screws (Qty. 2) to attach the fan cover.
The printer is ready for use.

Clean the Side Air Filters (Everest 600 only)

# Tool Required: Torx T10 screwdriver
1. Open the side cover.
a. Press the two side cover
latches to release the side cover.
Lower the side cover and the
b.
attached fan cover.
32
Fan Cover
Side Cover Latches
Fan Cover
Side Cover
Tacky
Roller 2
Air Filter
Screws
2000621_B