Optical Disc Recording Software Disclaimer; Safety And Compliance Information; Safety Precautions - Rimage Everest III Benutzerhandbuch

Rimage Everest™ III and 600 User Guide

Optical Disc Recording Software Disclaimer

This Product, Software, or Documentation may be designed to assist you in reproducing material in which you own the
copyright or have obtained permission to copy from the copyright owner. Unless you own the copyright or have permission to
copy from the copyright owner, you may be violating copyright law and be subject to payment of damages and other remedies.
If you are uncertain about your rights, you should contact your legal advisor. If you are neither in possession of the copyright
nor have authorization from the owner of the copyright, unauthorized copying of copyrighted material on an optical disc or any
other media violates national and international legislation and can result in severe penalties.

Safety and Compliance Information

This manual and the indications on the product allow proper and safe operation. The indication marks below help protect you
and other persons from injury, and equipment from damage.
, ,
Warning! According to ANSI (American National Standards Institute) standards, a warning is used to indicate situations
that could result in bodily injury to personnel operating or maintaining the equipment.
n
Caution: Indicates that failure to observe this guideline could result in loss or damage to the equipment, product,
software, or data.

Safety Precautions

To ensure safety, read these precautions and familiarize yourself with their meaning before using the equipment.
, ,
Warning!
•
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiant exposure.
•
Do not disassemble or use tools on the printer. All service procedures should be performed by a Rimage-authorized
technician, or sent in for Rimage-authorized repair.
•
Do not service the printer with the power cord plugged in the AC outlet.
•
The interior of the printer contains sharp edges.
•
The front bezel of the printer can be opened by hand. Do not insert your fingers.
•
Do not touch the heat roller.
n
Caution:
•
All equipment with AC line voltage, or low DC voltages, such as switches, power supplies, fuses, fans, and non-
stepper motors, must be replaced with Rimage-approved components to maintain the safety approval issued by UL.
•
Use only the supplied AC power cord. Fore more information or to order a new power cord, contact Rimage Customer
Service.
•
This product is designed for an office environment.
•
Do not use the printer if it is overheating or an abnormal smell is detected. This may result in a fire and an electric
shock. In case of heating or abnormal smell, immediately disconnect the cable from the outlet. Contact your Rimage-
authorized dealer for repairs.
•
Allow sufficient free space for opening the printer tray. Do not touch the printer tray while it is in motion.
•
If the side cover is opened while power is supplied, the printer will stop. Do not reach into the printer while it is in
operation. Do not attempt to bypass the door interlock.
•
This printer has no power switch. Power is disconnected completely by unplugging the cable. Rimage recommends
installing the printer in a position that allows immediate disconnection of the power cable. Always hold the plug when
disconnecting the cable from the outlet.
•
This printer has a voltage slide switch on the back of the unit. Before use, check that is set to the correct voltage.
Please do not use any voltage other than 110VAC or 220VAC. This could result in a fire and an electric shock.
n
Country-specific cautions for Wideband Data Transmission systems: 2400-2483.5 MHz
•
France: Do not use outdoors.
•
Italy: If used outside of own premises, general authorization is required.
•
Norway: This subsection does not apply for the geographical area within a radius of 20km from the center of NY-
Alesund.
4 2000621_B