Rimage Everest III Benutzerhandbuch Seite 34

2. Remove the fan cover from the side cover.
a. Remove the screws (Qty. 4) from the inside of the
side cover.
b. Close the side cover. The fan cover remains on the
work surface, with air filters exposed.
Tip: If the fan cover remains attached to the side
cover, gently lower the fan cover.
3. Remove the three air filters from the fan cover.
4. Clean the air filters.
a. Hold each air filter under running
water.
b. Allow the air filters to dry.
5. Prepare the printer for use.
a. When the air filters are dry, position them on the
inside of the fan cover.
b. Make sure that the tabs on the fan cover fit into the
holes in the side cover.
c. Open the side cover.
d. Insert and tighten the four screws to secure the fan
cover to the side cover.
e. Close the side cover and the attached fan cover.
The printer is ready for use.
2000621_B
Maintain the Everest Printer
Air Filters
Side Cover
Fan Cover
Tabs
Side Cover
Fan Cover
33