Clean The Tacky Rollers - Rimage Everest III Benutzerhandbuch

2. Clean the print head.
n
Caution! Do not scratch the print head.
Remember the following tips:
•
Always wipe from one end of the print head
to the other without stopping in the middle.
•
Only wipe the area indicated.
a. Apply isopropyl alcohol to the sponge swab.
b. Use the sponge swab to wipe across the print
head from one end to the other in the direction
shown.
c. Repeat as needed until the print head is clean
of dust and debris.
d. Use the sponge swab to remove any waxy
buildup from the roller below the print head.
3. Prepare the printer for use.
a. Install the print ribbon.
b. Install the print ribbon carrier.
c. Close all latches.
d. Close the side cover.
The printer is ready for use.

Clean the Tacky Rollers

#
Tools required: see above for translation
•
Sponge swabs with long handles (included in the Everest cleaning kit)
•
99% Isopropyl alcohol
1. Remove the print ribbon. For specific instructions, refer
to the Change the Print Ribbon
2. Clean tacky roller 1 (on the print ribbon carrier).
a. Apply isopropyl alcohol to the sponge swab.
b. Use the sponge swab to clean tacky roller 1.
c. Use the sponge swab to remove any waxy buildup
from other parts of the ribbon carrier.
d. Install the print ribbon on the print ribbon carrier.
2000621_B
procedure on page 25.
Maintain the Everest Printer
Area to Wipe
Roller
Print Ribbon Carrier
Wipe
Direction
Tacky
Roller 1
31