Section 8: Service And Maintenance; Cleaning; Fuse Replacement - Baylis Medical RFP-100A Gebrauchsanweisung

SECTION 8: SERVICE AND MAINTENANCE

The Generator requires no routine service or maintenance. If the Generator fails to
operate when plugged into a proper AC power receptacle and the POWER Switch (Fig.
5-2A) is turned "ON", a fuse may have blown. Contact Baylis Medical Company. The
Generator contains no user-serviceable parts. Disassembly and attempted repair by
unqualified personnel may create a hazardous condition and will void the warranty.
WARNING: DO NOT remove the cover of the Generator. Removing the cover may
result in personnel injury and/or damage to the Generator.
8.1.

CLEANING

The outer surface of the Generator may be cleaned with a mild soapy solution. DO NOT
immerse the Generator or its accessories in any liquid. Avoid caustic or abrasive
cleaners. If disinfecting is required, isopropyl alcohol may be used to clean the outer
surfaces.

8.2. FUSE REPLACEMENT

1. Unplug the Power Cord from the Generator.
2. Use a precision slot screwdriver to remove the fuse drawer
3. Remove BOTH fuses from the fuse drawer and discard them.
4. Select TWO new fuses according to the specifications in Section 9.1, according to
the supply voltage:
a. 100-120 VAC (Domestic Version – Canada/US):
Current
2.0A
b. 220-240 VAC (International Version):
Current
1.0A
5. Ensure the integrity of the new fuses by inspecting for physical damage that could
affect the function of the fuse. Replace if either or both look damaged.
6. Replace the fuses in the fuse drawer.
7. Replace the fuse drawer back into the Generator in the orientation that
MATCHES THE SUPPLY VOLTAGE.
WARNING: A mismatch of fuse type, Fuse Drawer orientation and Voltage Selector
Switch can result in permanent damage to the Generator!
Voltage Fuse Type
Rated
250V Slow Blow
Voltage Fuse Type
Rated
250V Time lag
28 DMR RFP-100 3.3 V-13 16-Jan-2012_EN.doc
Melting I²t Markings
14 I²t UL/CSA
Melting I²t Markings
11 I²t IEC