Programming Procedure - CAME ZVL370.01 Handbuch

PROGRAMMING PROCEDURE

A) Setting the programmer
1
2
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
3
Description : PROGRAMMAZIONE FIG1
PRG852-FIG.1
4
PROGRAMMAZIONE FIG1
5
Description : PROGRAMMAZIONE FIG3
PRG852-FIG.3
Description : PROGRAMMAZIONE FIG4
6
PRG852-FIG.4
Description : PROGRAMMAZIONE FIG5
PRG852-FIG.5
8
- after about 20 seconds of inactivity (without pressing any buttons) the programmer saves the set parameters
and leaves the programming mode.
- pressing the "SEL" button moves you back to step "1".
- pressing the "PROG" button moves you to the next stage.
Description : PROGRAMMAZIONE FIG 6
Drawing number :
DM0485
PRG852-FIG.6
Product Code : PRG852
Date : 24-05-2000
Draft : P.J.Heath
Before commencing make sure that the doors/gates are closed, the LCD display is off and the
LEDS L10,L11,L12 are all lit. LED L4 and L6 (if the closing direction travel limits for leaves 1
and 2 have been installed) are off (closing travel limit activated)
Keep the "PROG" button held down for more than 4 seconds: The letter
display "DS1" (this is the parameter definition mode).
After about 1 second the programming steps starting from step
the display.
If this is the first time the system has been programmed (EEPROM memory empty) none
of the parameters will have been set, meaning that the numbers will flash at each step; if
programming is being carried out on a system which has already been programmed, flashing
will depend on the value read from EEPROM when switching on (previously set parameters may
therefore be checked). Press the "PROG" button to change the setting.
As you can see in figures 4-5, pressing the "PROG" button when the display is not flashing
will force the number to flash.
This operation can be repeated as many times as required until the desired setting
has been obtained.
7
After the sixth stage, number "6" indicated, the next time you press the "SEL" button
moves you to stage
the system and the deceleration/ input sensor/worktime programming. There are now
three possibilities:
Description : PROGRAMMAZIONE FIG 7
PRG852-FIG.7
Pressing "SEL" moves you on to the next programming stage. It is not
possible to return to the previous programming stage so carry on until
the last stage and the cyclical programming cycle will return you to
stage "1".
Note: while "SEL" is pressed LED "L3" will remain lit.
, which indicates the separation between the configuration of
19
will appear on
will appear on