Herunterladen Inhalt Inhalt Diese Seite drucken

Applications; Liquid Temperature; Acids And Alkalis; Viscosity - Grundfos PUST04 Montage- Und Betriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 46

3. Applications

Grundfos pumping stations are used for collection and pumping
of drainage water, grey wastewater and sewage. The pump type
depends on the pumped liquid.

3.1 Liquid temperature

Maximum 40 °C. For higher temperatures, contact Grundfos.
Select the pump on the basis of knowledge of the
Caution
liquid temperature. See the installation and
operating instructions for the individual pumps.

3.2 Acids and alkalis

The pumping station is resistant to strong acids and alkalis as
well as solvents.
The pumps are supplied with the pump pit and normally capable
of withstanding pH values between 4 and 10. In case of doubt,
please contact Grundfos.

3.3 Viscosity

Very thick wastewater must not be led into the pit. See also the
installation and operating instructions for the pump.

3.4 Density

3
Maximum 1.1 tons/m
.

4. Pumping station system (PS.S)

This section applies only to pumping station systems consisting
of Grundfos-approved components/parts mentioned on the
nameplate of PS.S.
The pumping station system contains all the elements making the
pumping station function as one unit, and can contain the
following five elements:
pit
pump
pump controller
level controller
accessories.
The pumping station system may not always have all five
elements. However, it will always have a pit and a pump, but the
pump controller or the level controller may be incorporated in the
pump, and/or accessories may be omitted.

4.1 CE approval of PS.S

PS.S is CE approved in accordance with these directives and
standards:
EN 2006/42/EC, EU Machinery Directive
EN/ISO 12100, Safety of machinery - General principles for
design - Risk assessment and risk reduction.
In order to ensure safe transport and to fulfil customer requests,
the PS.S elements can be assembled on site. But the CE
approval of PS.S is only valid if the following conditions have
been fulfilled:
PS.S has been assembled correctly in accordance with the
installation and operating instructions for PS.S and the pit,
pump and control systems.
PS.S contains the Grundfos specified elements stated on the
PS.S nameplate. The PS.S nameplate is fitted inside the pit.
5

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Pust10Ps.r.17

Inhaltsverzeichnis