Assembly Instructions; Assembly - Overview - INSYS CombiLock 200 simplex Handbuch

CombiLock 200 simplex / pro / pro RFID

7 Assembly Instructions

for CombiLock 200 simplex, - pro und CombiLock 200 RFID
Assemble and install the electronic lock and the keypad according to these
assembly instructions.
Use the screws delivered with the system or screws exactly meeting the
specifications on the following pages. If requested, use screw retention fluid of
medium strength.
The assembly instructions are part of the VdS approval. Failure to follow these
instructions will invalidate that approval.
Uneven surfaces may cause functional loss.
Make sure that the lock is mounted to an even surface.
Applying too much force can cause damage.
Consequences which might arise from not being aware of the
danger.
Do not use more torque than 1 Nm when fastening the attachment
ring and do not use more torque than 10 Nm when fastening the
lock.
Make sure the electronic lock is protected against tampering from the
outside.
7.1

Assembly - Overview

There are 2 variants of the spindle, A and B.
Spindle A (below on the left hand side) consists of two half pipe pieces and cuffs.
Spindle variant B (below on the right) is a pipe.
System with spindle variant A
The attachment ring is to be mounted at the door with 4 cylinder screws M4x10.
Fasten the lock using 3 x cylinder screws.
Handbuch V.1.09A
System with spindle variant B
64
Caution
Caution
INSYS locks