GGP ITALY 102 Gebrauchsanweisung Seite 70

UNPACKING AND ASSEMBLY
Fit the spring (4) to hold the battery in place and make sure all the wires are in
front of the battery so that they don't get caught in the spring (4).
IMPORTANT
in the battery's manual ( ☛ 6.2.5).
IMPORTANT
ting in, never start the engine until the battery is fully charged!
WARNING!
!
safe handling and disposal.
3.5 GRASS-CATCHER ASSEMBLY
19 31
20
24
1
2
16
17
A) Join the upper part of the frame (1) to the front compo-
nent (2) using the screws and nuts (3) as shown. Fit the two
rubber caps (4) into the holes on the tube of front frame (2).
B) Fit the two rubber caps (4) into the holes on the tube of the
front frame (5) and fasten it onto the front component (2)
using the screws and nuts (6).
C) Position the angle plates (7) and (8), making sure they are
Always fully charge the battery according to the instructions
To prevent the safety device in the electronics card from cut-
Follow the battery manufacturer's instructions regarding
28
25
7
R
5
29
21
26
8
L
14
EN 11
A
4
3
3
2
B
2
6
C
9
1
7 - 8
9
5
1
4
6
5