GGP ITALY 102 Gebrauchsanweisung Seite 106

MAINTENANCE
Tighten the fixing screws (2) using a torque wrench set to 45-50 Nm. If
one or both shaft hubs (3) come off when dismantling the blades, make
sure the keys (4) are securely lodged in place.
6.3.2 C
UTTING DECK ALIGNMENT
The cutting deck should be properly set to obtain a good cut.
NOTE
should always be 5 - 6 mm lower than the rear.
– Put the machine onto a flat surface and check the tyre pressures;
– put 26 mm blocks (1) under the front edge
of the deck and 32 mm blocks (2) under the
rear edge, and thenput the lifting lever into
position «1»;
– loosen the nuts (3), the screws (5) and the
locknuts (4 – 6) on both the right and left
side, so that the deck is resting firmly on
the blocks;
– push the two connecting rods (7) to the
back and screw down the two nuts (3) on
each rod until the front part of the deck just
begins to rise both at the right and the left,
and then tighten the relevant locknuts (4);
– turn both the rear screws (5) until the rear of
the deck begins to rise both at the right and
the left, and then tighten the relevant lock-
nuts (6).
If you are unable to get the cutting deck
adjusted properly, consult a Licensed Service
Centre.
For achieving good results from cutting, the front part
1 = 26 mm
2 = 32 mm
4 3
5
6
EN 47
7