GGP ITALY 102 Gebrauchsanweisung Seite 69

EN 10 UNPACKING AND ASSEMBLY
Move the front wheels to turn both the
shaft (2) and the steering wheel (1) about
a quarter of a turn in order to get to the
2
hole (3) on the shaft.
Line up the hole on the steering wheel
1
4
3
hub (4) with the hole on the shaft (3) and
5
insert the pin supplied (5) using a ham-
mer, ensuring that the end comes com-
pletely through to the opposite side.
NOTE
To avoid damaging the steering wheel, use a punch or a
screw-driver of the same size as the pin when hammering it in the last part
3.3 FITTING THE SEAT
4
Raise the adjustment lever (3) and fit the
seat (1) in the slide (2), introducing it from
the steering wheel's side, till the seat
engages in one of the 6 positions.
At this point the seat is engaged and can-
2 1 3
not be completely removed unless the
lever (4) is pressed, freeing it from its
retainer
3.4 ASSEMBLY AND CONNECTING
3
THE BATTERY
1
Position the battery (1) in its compart-
ment under the seat.
Connect the red cable (2) to the positive
terminal (+) and the black cable (3) to the
negative terminal (–) using the supplied
screws and following the illustrated
4
2
sequence.