Cleaning; Cleaning The Window And Plastic Parts; Information On Disposal And Recycling; Troubleshooting - Videotec Ulisse Compact Delux Bedienungsanleitung

• Restore the DIP 3 as shown in the figure.
DIP2
Fig. 24
• Close the configuration flap.
Pay attention to the fixing. Tightening
torque: 1.6Nm
• Power the unit.
Once the factory default procedure has
terminated, you need to configure the unit
as described in the relevant chapter (9.1
Default IP address, page 16).
During the normal operation of the product
the dip-switches must be set as shown in
the figure (Fig. 24, page 19).

13 Cleaning

13.1 Cleaning the window and
plastic parts
Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
We recommend using a soft cloth with neutral soap
diluted with water or specific products to clean the
glasses lenses.
MNVCUCHDB_1905_EN
DIP3
DIP1
14 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The symbol of the crossed out bin is marked
on all products to remember this.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.

15 Troubleshooting

Contact an authorized support centre if the
problems listed below persist or you have
any other issues that are not described
here.
PROBLEM The product does not go on.
CAUSE Wiring error, blown fuse.
SOLUTION Make sure the connections are
correct. Check the continuity of
the fuses and replace them with
the indicated models should they
fail.
PROBLEM The shooting area do not
correspond to the selected
preset position.
CAUSE Loss of absolute position
reference point.
SOLUTION Reset the equipment by
switching off and on again.
19