Switching On And Off And Adjusting The Speed; Using The Blade Assembly - Silvercrest SKMM 1000 A2 Bedienungsanleitung

7.5 Switching on and off and
adjusting the speed
Use the dial 12 to switch the device on and off and select
the speed setting:
Switch
position
Pulse function:
- Hold the dial 12 in the P position to
switch on the device.
- Release the dial 12 to switch off the
P
device.
- Enables working with several brief
pulses in a row – recommended e.g.
for herbs and onions
0 Turned off
1 Speed setting 1 (normal)
2 Speed setting 2 (high)
NOTE: when selecting the speed setting, consult the rec-
ommendation in the tables.

8. Using the blade assembly

DANGER! Risk of injury!
The blades of the blade assembly 8 are very sharp.
Do not touch them. When you are not using the blade
assembly, push the blade guard on to the blades.
Application area:
The blade assembly 8 is suitable for chopping onions,
herbs, vegetables, fruit, parmesan and meat. You can also
use the blade assembly to knead dough.
Function
• Removing the blade
guard:
Pull the blade guard in the
middle slightly away from the
blade assembly and remove
this by pulling upwards.
• Attaching the blade
guard:
Place the blade assembly 8
into the blade guard from the
top. Make sure that both
blades are completely pro-
tected.
WARNING! Risk of material damage!
Do not use the device to chop particularly hard food
such as bones or nutmegs.
The blade assembly is not suitable for grain, ice, nuts
or similar types of hard food.
Processing table for chopping:
Ingredients Preparation
cutting into
cubes,
Meat
approx.
2 x 2 cm
quartered,
Onions
without peel
Garlic without peel
cutting into
pieces,
Carrots
approx.
2 x 2 cm
Processing table for kneading:
Ingredients max. quantity
Yeast dough max. 500 g of flour approx. 3 min.
WARNING! Risk of material damage!
Do not operate the device continuously with the blade
assembly 8 in place for more than 3 minutes. After
this, the device must remain switched off until it has
cooled down to room temperature.
The device is unsuitable for heavy dough (e.g. full-
grain bread dough) or large amounts of dough. It is
possible to process sizeable amounts of dough in por-
tions.
Required accessories:
- Working container 9
- Blade assembly 8
- Lid 3 with food pushers 1, 1, 2
And this is how it works:
(For assembly see Figure M)
1. Position the working container 9 on the base unit 13.
Turn the working container slightly in a clockwise di-
rection until it is heard to lock into place.
2. Place the blade assembly 8 into the working contain-
er 9.
3. Fill the ingredients into the working container 9. Fur-
ther ingredients can be added at a later time through
the food chute.
4. Place the lid 3 with the food pushers 1, 1, 2 onto the
working container 9. Turn the lid slightly in a clock-
wise direction until it is heard to lock into place.
5. Connect the mains plug 10 to a wall socket.
6. Use the dial 12 to select the desired speed setting.
max. Processing
Switch
quantity time
approx.
2 / P
500 g
30 - 60 sec.
approx.
500 g
30 - 60 sec.
approx.
500 g
30 - 60 sec.
approx.
2 / P
500 g
30 - 60 sec.
Processing time Switch
GB
P
P
1
31