Using The Grater And Cutting Disc - Silvercrest SKMM 1000 A2 Bedienungsanleitung

12. Using the grater and cutting
disc
Application area:
The coarse grater and cutting disc 4 and the fine grater
and cutting disc 5 are suitable for grating and cutting slic-
es of vegetables, fruit, potatoes and cheese. Both sides of
these discs can be used. On the one side for grating and
on the other side for cutting slices.
Both discs are marked with a pattern for orientation.
Pattern
Coarse grater and cutting disc 4
Fine grater and cutting disc 5
WARNING! Risk of material damage!
Do not exert too much pressure on the grater or cutting
disc 5/4. Apply an even pressure so that the motor
does not become blocked.
Processing table - cutting:
Ingredients max. quantity
Carrots 500 g
Courgettes 500 g
Leeks 500 g
Beetroots
500 g
(peeled)
Processing table - grating:
Ingredients max. quantity
Carrots 500 g
WARNING! Risk of material damage!
Do not operate the device continuously with the grater
and cutting disc 5 or 4 in place for more than
2 minutes. After this, the device must remain switched
off until it has cooled down to room temperature.
Required accessories:
- Working container 9
- Axle 17
- Fine grater and cutting disc 5 or
coarse grater and cutting disc 4
- Lid 3 with food pushers 1, 2
34 GB
Grater and cutting disc
max.
processing time
approx. 2 min.
approx. 2 min.
approx. 2 min.
approx. 2 min.
max.
processing time
approx. 2 min.
And this is how it works:
(For assembly see Figure J)
1. Position the working container 9 on the base unit 13.
Turn the working container slightly in a clockwise di-
rection until it is heard to lock into place.
2. Place the axle 17 into the working container 9.
3. Position the grater and cutting disc 5 or 4 on the axle
in such a way that the tool with which you want to
work is positioned on top.
Cutting
4. Place the lid 3 with the food pushers 1, 2 onto the
working container 9. Turn the lid slightly in a clock-
wise direction until it is heard to lock into place.
5. Connect the mains plug 10 to a wall socket.
6. Remove the midi food pusher 1 and fill the prepared
ingredients into the food chute.
7. Turn the dial 12 to position 1 (grating) or 2 (cutting)
and use the midi food pusher 1 to press the ingredi-
ents down with a light, even pressure. Ingredients
with a long shape, such as carrots, courgettes, cu-
cumbers can be pressed downward without a food
pusher if they protrude from the top of the food chute.
Switch
8. Stop (dial 12 in the position 0) before all of the in-
2
gredients in the food chute are processed so that you
2
can fill in more ingredients.
9. Process all ingredients portion by portion. Empty the
2
working container 9 from time to time if it is filled up
2
to the MAX mark.
10. When the process is completed, switch the dial 12 to
0 and pull out the mains plug 10.
11. Turn the lid 3 slightly in an anticlockwise direction
and remove it.
Switch
12. Turn the working container 9 slightly in an anticlock-
wise direction and remove it.
1
13. Hold the axle 17 at the top end and lift it out with the
grater and cutting disc 5 or 4.
14. Remove the processed ingredients from the working
container 9.
15. Clean all of the accessories that have been used im-
mediately if possible.
Grating