Switching On / Off; Measuring Out Ingredients; Making Pasta - Silvercrest IAN 313492 Bedienungs- Und Sicherheitshinweise

Connect the device to the safety socket.
Note: When connecting to the power supply,
the device will beep and the LC display
flash briefly.

Switching on / off

Press the ON / OFF button
pear in the LC display
enter standby mode.
Note: If you press the ON / OFF button
during operation, the device will stop and will
enter standby mode.

Measuring out ingredients

Reference table for the proportions of liquid and
flour:
Measur-
Measuring cup for liquids
ing cup
for flour
12
Flour Water
2 cups 160 ml
(430 g)
1 cup 80 ml
(215 g)
Note: The flour quantities given refer to a level
cup. Use the dough scraper
flour.
26 GB/IE
will
2a
. „ON" will ap-
2b
and the device will
2a
2b
11
Mixture of Egg /
thin, liquid water mix-
vegetable ture
juice with /
without water
160 ml 180 ml
(2 medium
eggs
topped
up with
water)
80 ml 90 ml
(1 medium
egg
topped
up with
water)
to smooth out the
14
Note: The eggs must be mixed and whisked with
the liquid before use.
Note: One cup of flour makes about 250 g of pasta.
ATTENTION! Do not exceed the product's capacity!
Make sure that you strictly conform to the
recommended proportions of flour and water.
Disturbances due to use which diverges from
the handbook lead to the loss of the warranty
claim.

Making pasta

ATTENTION! Do not use pureed vegetables, just
thin juice. Only use the opening on the left hand
side of the lid to pour in liquid ingredients.
4
Open the lid (see fig. I).
4
Measure out the flour required using the
measuring cup for flour
Note: The flour quantities given refer to a
level cup. Use the dough scraper
out the flour.
Pour the flour into the mixing chamber
fig. J).
Put the lid in its place in the housing
4
Measure out the liquid required using the
measuring cup for liquids
the measuring cup for liquids
and read horizontally from the front. Then add
it to the mixing chamber
Insert the plug into a suitable socket and press
the ON / OFF button
Press the automatic button
priate for the quantity of flour (1 cup or 2 cups
flour) or alternatively first press „mix" and then
„press out". Pour the right quantity of liquid
(according to the proportions of flour and
liquid in the reference table) through the left
side of the lid once the mixing paddle
started to move. The motor will start, the dough
will be kneaded for 3 minutes, and then the
kneading direction will be changed and dough
will start to be pressed out. The LC display
shows the remaining total manufacturing time.
The device stops automatic and shows „OFF"
.
12
to smooth
14
(see
1
.
2
. To do so, place
11
on the table
11
(see fig. K).
1
.
2b
which is appro-
2d
has
5
2a