Switching On/Off And Reverse Mode; Removing Blockages; Preparing A Sorbet; Disassembly - Silvercrest SSJ 300 A1 Bedienungsanleitung

9.4 Switching on/off and
reverse mode
• To turn on the device, set the on/off
switch 12 to 1.
• To turn off the device, set the on/off
switch 12 to 0.
• If you set the on/off switch 12 to R, you
will start reverse mode. With this func-
tion you can eliminate small blockages.

9.5 Removing blockages

If a piece of fruit or vegetable is blocking the
auger 5, it must be removed immediately.
You can recognise a blockage...
... if no more juice comes out of the
juice outlet 9, even though pieces of
food are still in the chute.
... if the pieces of food in the food
chute 3 no longer slide down,
... if there are unusual sounds, or
... if the motor becomes audibly slower.
Reverse mode
First, try to fix the blockage by using reverse
mode:
1. Set the on/off switch 12 in sequence
to 0, for approx. 2 seconds to R (re-
verse mode) and again to 0.
2. Turn the on/off switch 12 to 1. Check
whether the device is working normally.
3. Repeat the process, if necessary.
Cleaning the device
If this does not resolve the blockage, follow
these steps:
1. Pull out the mains plug 11.
2. Take the device apart (see "Disassem-
bly" on page 36).
3. Clean the auger 5, the holder 7, the
screen assembly 6 and the working
container 8 (see "Cleaning" on
page 37).
4. Reassemble the parts and proceed with
juice extraction.
36 GB

10. Preparing a sorbet

WARNING! Risk of material dam-
age!
The device is designed to prepare sor-
bet for up to 5 minutes maximum oper-
ating time without interruption. After
this, the device must remain switched off
until the base unit 13 has completely
cooled down.
1. Assemble the device for sorbet prepa-
ration (see "Insert the sorbet assembly"
on page 33).
2. Prepare half frozen fruit pieces (see
"Preparing food for sorbet prepara-
tion" on page 34).
3. Proceed in the same way as for juicing.
The finished sorbet is ejected through
the juice outlet 9.
4. Mix the sorbet again with a spoon and
serve it immediately.

11. Disassembly

DANGER! Risk of electric
shock!
Pull the mains plug 11 out of the wall
socket before you disassemble and
clean the device.
1. Pull the food pusher 1 off upwards
from the food chute 3.
2. Remove the filling aid 2.
3. Turn the lid 4 anticlockwise until
the point symbol
opened lock symbol
lid 4.
4. Close the drip stopper 10.
5. Pull out upwards the screen assembly 6 /
sorbet assembly 19 complete with the
auger 5. While doing this, move these
parts somewhat back and forth to
make them easier to release.
•
points to the
. Remove the