Auto Setup; Introduction; Optimizer Microphone Setup - Yamaha RX-V1500 Bedienungsanleitung

AUTO SETUP

Introduction

This receiver employs YAMAHA Parametric Room
Acoustic Optimizer (YPAO) technology which lets you
avoid troublesome listening-based speaker setup and
achieves highly accurate sound adjustments. The supplied
optimizer microphone collects and analyzes the sound
your speakers produce in your actual listening
environment.
y
The basic setup feature (page 31) is useful if you want to set up
your system quickly and with minimal effort. However, we
recommend that you come back and perform auto setup later to
take advantage of YPAO and enjoy even higher fidelity.
Notes
• Please be advised that it is normal for loud test tones to be
output during the auto setup procedure.
• If auto setup stops and error messages appear on the screen,
follow the troubleshooting on page 29.
YPAO performs the following checks and makes
appropriate adjustments to give you the best possible
sound from your system.
WIRING
Checks which speakers are connected and the polarity of
each speaker.
DISTANCE
Checks the distance of each speaker from the listening
position and adjusts the timing of each channel.
SIZE
Checks the speaker's frequency response and sets the
appropriate low frequency crossover for each channel.
EQUALIZING
Adjusts frequency and levels of each channel's parametric
equalizer to reduce coloration across the channels and
create a cohesive sound field. This is particularly
important if you use different brands or sizes of speakers
for some channels or have a room with unique sonic
characteristics.
YPAO equalizing calibration incorporates three
parameters (frequency, level and Q factor) for each of the
seven bands in its parametric equalizer to provide highly
precise automatic adjustment of frequency characteristics.
LEVEL
Checks and adjusts the sound level (volume) of each
speaker.
26
AUTO SETUP

Optimizer microphone setup

1
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
TUNER
YPAO
Notes
• After you have completed the auto setup procedure, be
sure to disconnect the optimizer microphone.
• The optimizer microphone is sensitive to heat.
–Keep it away from direct sunlight.
–Do not place it on top of this unit.
2
Place the optimizer microphone on a flat
level surface with the omni-directional
microphone head upward, at your normal
listening position.
If possible, use a tripod (etc.) to affix the optimizer
mic at the same height as your ears would be when
you are seated in your listening position.
PRESET/
PRESET
A/B/C/D/E TUNING FM/AM MEMORY
/TUNING
EDIT MAN'L/AUTO FM
PHONES S VIDEO
OPTIMIZER
MIC
SILENT
Optimizer microphone position
(U.S.A. model)
TUNING
MODE
AUTO/MAN'L MONO
VIDEO L AUDIO R OPTICAL
VIDEO AUX