Recording - Yamaha RX-V1500 Bedienungsanleitung

RECORDING

Recording adjustments and other operations are
performed from the recording components. Refer to the
operation instructions for those components.
1 2
INPUT
PURE DIRECT
STANDBY
/ON
PRESET/
A/B/C/D/E TUNING
TUNER
SPEAKERS MULTI CH INPUT MODE
A B INPUT
MIC
YPAO
POWER
TV
A
PHONO
V-AUX
DTV
1
Turn on the power of this unit and all
connected components.
2
Select the source component you want to
record from.
INPUT
or
Front panel
3
Start playback (or select a broadcast station)
on the source component.
4
Start recording on the recording component.
y
Always do a test recording before you start an actual recording.
48
RECORDING
VOLUME
PRESET TUNING RDS MODE
/TUNING FM/AM MEMORY MODE /FREQ EON PTY SEEK
PROGRAM
EDIT MAN'L/AUTO FM AUTO/MAN'L MONO MODE START TONE CONTROL
PHONES S VIDEO VIDEO L AUDIO R OPTICAL
SILENT VIDEO AUX
(U.S.A. model)
SYSTEM
POWER STANDBY POWER 1
AV
B INPUT MODE SLEEP
TUNER CD MULTI CH IN
2
CBL/SAT MD/TAPE CD-R
VCR 1 DVR/VCR2 DVD
PHONO TUNER CD
V - AUX
CBL/SAT MD/TAPE
DTV VCR 1 DVR/VCR2
Remote control
Notes
• When this unit is set in the standby mode, you cannot record
between other components connected to this unit.
• The setting of TONE CONTROL, VOLUME, SPEAKER
LEVEL (page 60) and programs does not affect recorded
material.
• A source connected to the MULTI CH INPUT jacks of this unit
cannot be recorded.
• S-video and composite video signals pass independently
through this unit's video circuits. Therefore, when recording or
dubbing video signals, if your video source component is
STRAIGHT
connected to provide only an S-video (or only a composite
EFFECT
video) signal, you can record only an S-video (or only a
composite video) signal to your VCR.
• Digital signals input to the DIGITAL INPUT jacks are not
output to the analog AUDIO OUT (L/R) jacks for recording.
Likewise, analog signals input to the AUDIO IN (L/R) jacks are
not output to the DIGITAL OUTPUT jack. Therefore, if your
source component is connected to provide only digital (or
analog) signals, you can only record digital (or analog) signals.
• A given input source is not output on the same REC OUT
channel. (For example, the signal input from VCR 1 IN is not
output on VCR 1 OUT.)
• Check the copyright laws in your country to record from
records, CDs, radio, etc. Recording of copyrighted material may
infringe copyright laws.
If you playback a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.
Special considerations when recording
MULTI CH IN
DTS software
CD-R
The DTS signal is a digital bitstream. Attempting to
digitally record the DTS bitstream will result in noise
DVD
being recorded. Therefore, if you want to use this unit to
record sources that have DTS signals recorded on them,
the following considerations and adjustments need to be
made.
For DVDs and CDs encoded with DTS, when your player
is compatible with the DTS format, follow its operation
instruction to make a setting so that the analog signal will
be output from the player.