Starting Up Handy 180 - LORCH Handy 180 Control Pro Bedienungshandbuch

15

Starting up Handy 180

Abb. 8: Control console Handy 180 DC BasicPlus
Torch control socket
9
plug the torch control plug into this socket.
LED malfunction
35
is lit constantly when the machine is over-
heated, LED flashes in case of a malfunction.
Ignition of an arc is not possible.
The LED flashes in a self-test mode directly
after switching on the machine.
LED mains
36
is lit when the machine is operational.
LED MMA mode
38
is lit when MMA mode is selected.
LED 2-stroke
39
is lit when 2-stroke mode is selected (only in
TIG mode)
press torch button = arc is ignitted
release torch button = arc goes out
LED TIG
40
is lit when TIG mode is selected.
LED 4-stroke
41
is lit when 4-stroke mode is selected (only in
TIG mode).
press torch button = ignition current flows
release torch button = welding current flows
press torch button = end current flows
release torch button = arc goes out
- 32 -
35 36
9
37 38 39 40 41
43
LED slope
42
is lit when function slope is activated.
2-stroke - at the start of the weling process the
machine rises the current from ignition current
to the selected welding current (upslope). At
the end of the welding process the machine
decreases the current from welding current to
min. current (downslope).
4-stroke - at the start of the weling process the
machine rises the current from start current to
the selected welding current (upslope). At the
end of the welding process the machine de-
creases the current from welding current to end
current (downslope).
Mode key
43
is used to select the different modes/functions.
Knob welding current
37
is used to set the desired welding current.
Starting up Handy 180
42
05.11