TOOLCRAFT TC-LDM 60 R Multi Bedienungsanleitung Seite 56

Configure the measuring reference. The
horizontal line shows the position of the
measuring reference line. By default, the
measuring reference is the rear side.
• Press the MEAS button (4) to change the location of the
zero position. The following measurement references are
available:
Digital spirit level
The spirit level helps you to precisely determine horizontal or
vertical surfaces or the position of the device.
Press the MEAS (4) button to switch on the
digital spirit level.
Press the
56
Starting point: Rear side
The length of the
housing is included in the
measured value.
Starting point: Tripod
thread
Starting point: Front
The length of the housing
is not included in the
measured value.
button (10) to exit this function.