Signal Description - Agilent Technologies Turbo-V 1K-G Bedienungshandbuch

17 Technical Information
Interconnections – Controller Model 9698978M004
Tab. 3
PIN N.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15

Signal Description

Start/Stop: input signal to start or stop the pump. With the supplied
cover connector the START/STOP (+) signal is connected to the +24
Vdc pin and the START/STOP (-) signal to the GROUND pin: in this
condition the pump automatically starts as soon as the controller
recognises the input supply ("Plug & Pump").
Interlock: input signal to control the pump rotation. With the
supplied cover connector the interlock (+) signal is connected to the
+24 Vdc pin and the interlock (-) signal to the GROUND pin.
Speed setting: PWM input signal to set the pump speed. The PWM
signal characteristics must be the following:

250/294
Signal characteristics and use
SIGNAL NAME
START/STOP (+)
START/STOP (-)
INTERLOCK (+)
INTERLOCK (-)
SPEED SETTING (+)
SPEED SETTING (-)
SOFT START (+)
SOFT START (-)
+24 Vdc
SPARE
PROGRAMMABLE SET POINT
SPARE
FAULT OUTPUT
PROGRAMMABLE ANALOG SIGNAL (+)
GROUND

PROGRAMMABLE ANALOG SIGNAL (-)

frequency: 100 Hz +/-20%
Turbo-V 1K-G Retrofit User Manual / 87-900-996-01 (B)
IN-/OUTPUT
IN
IN
IN
IN
IN
IN
IN
IN
OUT
OUT
OUT
OUT
OUT