Turbo-V 1K-G Retrofit Switching Off; Emergency Stop - Agilent Technologies Turbo-V 1K-G Bedienungshandbuch

16 Instructions for Use
Use

Turbo-V 1K-G Retrofit Switching off

To switch off the Turbo-V 1K-G Retrofit it is necessary to remove the
mains. The integrated controller immediately stops the pump.
The Turbo-V controller must be powered with 3-wire power cord (see
WARNING!
orderable parts table) and plug (internationally approved) for user's safety.
Use this power cord and plug in conjunction with a properly grounded power
socket to avoid electrical shock and to satisfy CE requirements. High voltage
developed in the controller can cause severe injury or death. Before servicing
the unit, disconnect the input power cable..

Emergency Stop

To immediately stop the Turbo-V 1K-G Retrofit in an emergency
condition it is necessary to remove the supply cable from the mains
plug.
236/294 Turbo-V 1K-G Retrofit User Manual / 87-900-996-01 (B)