Maintenance And Cleaning - Parkside PDMS 6.3 A1 Originalbetriebsanleitung

♦ By turning the speed setting
wheel in the respective
direction (marked with ON/
OFF), you switch on the grind-
ing machine and increase
or decrease the speed (see
figure 3).
Fig. 3
Maintenance and
cleaning
WARNING! RISK OF
INJURY! Disconnect
the grinder from the
compressed-air
supply before
carrying out mainte-
nance work.
PDMS 6.3 A1
CAUTION!
► Before maintenance, clean
off any hazardous substanc-
es that may (due to working
processes) have accumulat-
ed on the appliance. Avoid
all skin contact with these
substances. If the skin comes
into contact with hazardous
dusts, this can lead to severe
dermatitis.
If dust is produced or
swirled up during mainte-
nance, it can be inhaled.
NOTE
To ensure correct functioning
and long-term durability of the
sander, pay attention to the
following points:
■ Sufficient and continuously
intact oil lubrication is highly
important for optimum function-
ing.
■ Check the idle speed regularly
and after any maintenance is
performed:
use a rev counter and perform
the measurement without any
clamped tools.
GB │ IE │
37 ■